Application of stainless steel mesh belt in shot blasting machine

  • Published:
  • Views:271
  • By:Gujarati Trade

The stainless steel mesh belt of the shot blasting machine is suitable for mass production of surface cleaning of small and medium-sized workpieces. The equipment of this specification is suitable for engine connecting rods, gears, diaphragm springs, disc-shaped workpieces, etc. It is widely used in casting and automobile manufacturing industries, and has high production efficiency. High, good sealing effect.

The stainless steel mesh belt of the shot blasting machine is also especially suitable for complete, comprehensive and continuous shot blasting processing of flat workpieces and large and complex workpieces. The shot blasting machine is equipped with 4 or 8 high-power "130" shot blasting wheels and fixed around the shot blasting machine box (vertically and horizontally inclined respectively), so that it can handle very complex, with "pocket" Or workpieces in areas where shot is difficult to reach. The high wear-resistant metal mesh belt can adjust its tension to realize parts transmission. The special mesh belt guide rail enables the shot blasting wheel below to be shot blasted only through a certain mesh belt position, which means that any untreated surface of the workpiece will be reduced to a minimum, compact structure, convenient loading and unloading, high technical content, etc. .

working principle:

After adding the prescribed workpieces on the mesh belt of the equipment, the machine starts, and the workpieces are driven. At the same time, the projectiles thrown out by the shot blaster at high speed form a fan-shaped beam, and hit on the surface of the workpiece equably, so as to achieve the purpose of cleaning. The thrown projectiles and sand flow into the screw conveyor at the bottom from the small holes on the mesh belt, and are sent into the elevator through the screw conveyor, and are lifted by the elevator to the separator for separation. The dust-laden gas is sucked by the fan to the dust collector and filtered, then becomes clean air and discharged into the atmosphere. The dust is blown back by the air and falls into the dust collection box at the bottom of the dust collector, which can be removed regularly by the user. The waste sand flows out from the waste pipe and can be reused by the user. The shot-sand mixture is recovered into the chamber through the recycling pipe, and reused after being separated by the separator.

Send Inquiry